Flasher Archive

[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]


Subject: RE: FLASH: disable buttons?
From: Interpaul
Date: Mon, 31 Jan 2000 14:44:08 GMT

-----Oorspronkelijk bericht-----
Van: owneratchinwag [dot] com [owneratchinwag [dot] com]Namens">mailto:owneratchinwag [dot] com]Namens Shaun Brazier
Verzonden: maandag 31 januari 2000 15:24
Aan: flasheratchinwag [dot] com
Onderwerp: Re: FLASH: disable buttons?


hi

You could have your links(active buttons) in one frame of an MC and then
have your non active buttons(dead instance of your button graphic) in
another frame of the MC. Using Tell Target, you could alternate between
these two frames, presenting active buttons and non active buttons when
required?

Just a thought. Am I on the right tracks?

Regards

Shaun
-----
Yes, you are. Only I was hoping there would be a faster solution.

Thanks,

Paul


flasher is generously supported by...
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
flashforward2000 and The Flash Film Festival
"The Worlds Premier Flash Solutions Conference and Expo"
March 27-29, Nob Hill Masonic Center, San Francisco, California

-Register before Feb 25 and save $200!!-- www.flashforward2000.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
To unsubscribe or change your list settings go to
http://www.chinwag.com/flasher or email helpatchinwag [dot] com


Replies
  Re: FLASH: disable buttons?, intertwine

Replies
  Re: FLASH: disable buttons?, Shaun Brazier

[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]