Flasher Archive
[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]
Subject: | Re: Using Onload to determine loading order |
From: | Jason Nugent |
Date: | Sat, 23 May 1998 20:57:41 +0100 |
Hey Andrew,
I figured I'd take this time for a shameless self-plug :) Head
off to the JavaScript "No Content" website that I write articles for to
see an example of the onLoad command. If it's not on our site, you can't
do it with JavaScript :)
http://www.btinternet.com/~martin.webb
hth,
Jason
On Sat, 23 May 1998, Andrew Ayres wrote:
> hi again,
>
> Thanks a lot John for pointing out the solution I need. I'm now scouring
> the Web (tried the Flash tech resource) and newgroups for an example of how
> to use the Javascript onload command in this way (I'm a non-programmer!)
>
> If anyone can point out a good link, or give example code, it'd help me.
>
> cheers, Andrew
>
>
> At 03:58 PM 5/22/98 -0400, you wrote:
> >For Flash 2 JavaScript must be enabled:
> >Load a blank or Static logo in the right frame.
> >Replace the contents of the right frame with the Spaghetti using onLoad
> >in frameset. onLoad in the frameset will not execute until all the
> >frames are loaded. In your case the left and right(a temporary blank or
> >Logo page).
> >John Croteau croteau


>
>
> ------------------------------------------------------------------------
> To UNSUBSCRIBE send: unsubscribe flasher in the body of an
> email to list-manager


> N.B. Email address must be the same as the one you used to subscribe.
> For info on digest mode send: info flasher to list-manager

>
---------------------
Jason Nugent, BSc(Hons)
ap958

Certified Webmaster Wrapped in the shroud of this grey home
I'll paint a picture all my own
I'll paint a picture"
Live to ride,
Ride to Live. -Anacrusis
********************************************************************
The Best Place for Sport on the net! - Sportscience www.sportsci.org
********************************************************************
------------------------------------------------------------------------
To UNSUBSCRIBE send: unsubscribe flasher in the body of an
email to list-manager


N.B. Email address must be the same as the one you used to subscribe.
For info on digest mode send: info flasher to list-manager

Replies
Using Onload to determine loading order, Andrew Ayres
[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]