FLASH: problem with overflow graphics

[Rule, Kristin]

Hi flashers, 


Have any of you ever seen this problem:  i have published a movie and

embedded it into HTML (published it)  and set the movie to 100% in size.

When I do this, some of the graphics that overflowed out of my work area are

showing.  When i publish the movie to match movie in pixels, it is fine, but

not when it is set too 100%.  How do i keep the movie 'clean' on the edges,

so that only the graphics in my work area show when i publish the movie.

Why is the movie showing this 'overflow' of graphics? 


thanks in advance!


kristin




flasher is generously supported by...

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  Streaming Media WEST '99 Conference & Exhibition

  "The Worlds largest Internet Audio & Video Event"

 December 7 - 9, San Jose Convention Center, California


Reserve your space today at http://www.streamingmedia.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  To unsubscribe or change your list settings go to

http://www.chinwag.com/flasher or email

helpchinwag [dot] com