Re: FLASH: Rotating Globe

[Jayma]

Larry:


I created the frames (30 of them) in RayDream Studio.  I exported them as

sequenced  PICTs  (I am on a Mac, and bmp is not compatable).   To clarify,

each original image is 40K, times 30 files imported into Flash total. For

just those 30 frames, it came out to be over 200K for the .swf, which is

way too long when you need to place it into a much longer movie (over 3

minutes in length). I tried tracing and optimizing in Flash, but this only

increase my file size by 4x. I didn't put the traced/optimized up to view,

because it was over 800K and nobody is going to look at that!  I hope this

clarifys what my problem is.


Thanks.


Jayma


>In a message dated 2/13/99 7:33:32 PM Eastern Standard Time,

>

jaymalandearthlink [dot] net writes:

>

><< http://www.danaeweb.com/demos/jk/globe.html >>

>i just opened it on ie4.0 aols browser even it took less than 20 seconds to

>open which is long by some standard?

>so when you sya you traced it it was a .bmp file originally or maybe more to

>my point did this start in bryces or microsoft 3d and then get saved as a

>.bmp? what is the file size of your original .bmp?

>Larry

>

>------------------------------------------------------------------------

>To UNSUBSCRIBE send: unsubscribe flasher in the body of an

>

email to list-managershocker [dot] com. Problems to: ownershocker [dot] com

>N.B. Email address must be the same as the one you used to subscribe.

>

For info on digest mode send: info flasher to list-managershocker [dot] com

------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com