Flasher Archive

[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]


Subject: Re: FLASH: setting x&y of swf file
From: julie
Date: Sun, 6 Feb 2000 21:42:32 GMT

You are my new hero Cheri.
It works perfectly! You just saved me so much time.

Thanks so much.

-julie

> From: "Cheri Harder" <chericaathome [dot] com>
> Organization: Advantage Web Solutions
> Reply-To: flasheratchinwag [dot] com
> Date: Sun, 6 Feb 2000 11:18:50 -0800
> To: <flasheratchinwag [dot] com>
> Subject: Re: FLASH: setting x&y of swf file
>
> Hi Julie
>
> Check out the load movie into target. You can make a blank (empty) movie
> clip and place it where you want your new movies to show. Then you change
> your load movie command to load into target. It is difficult to understand
> the placement of your movie within this movie clip (something like the
> center of the swf loads to the top left corner of the mc...) but once you
> get it aligned the first time, all the others should be a snap.
>
> I'd look up the positioning, but have to get going....if you haven't figured
> it out in a couple hours, get back to the list, or me personally. I should
> have time then.
>
> HTH
> ~~~~Cheri Harder~~~~~
> charderatawsolution [dot] com
> Advantage Web Solution
> "Developing your internet storefront"
> www.awsolution.com
>
>> I have about 30 different swf files that were made for 600x350. I don't
>> want them to all be in one fla file, because it would be way to big to
> run.
>>
>> I now need to be able to call them using the load movie command into an
> swf
>> that is 750x550. When an swf is called it automatically loads it into the
>> top left corner and I want them to center themselves to the bottom middle.
>
>
> flasher is generously supported by...
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> flashforward2000 and The Flash Film Festival
> "The World’s Premier Flash Solutions Conference and Expo"
> March 27-29, Nob Hill Masonic Center, San Francisco, California
>
> -Register before Feb 25 and save $200!!-- www.flashforward2000.com
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> To unsubscribe or change your list settings go to
> http://www.chinwag.com/flasher or email helpatchinwag [dot] com


flasher is generously supported by...
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
flashforward2000 and The Flash Film Festival
"The World’s Premier Flash Solutions Conference and Expo"
March 27-29, Nob Hill Masonic Center, San Francisco, California

-Register before Feb 25 and save $200!!-- www.flashforward2000.com
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
To unsubscribe or change your list settings go to
http://www.chinwag.com/flasher or email helpatchinwag [dot] com


Replies
  Re: FLASH: setting x&y of swf file, Cheri Harder

[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]