Flasher Archive

[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]


Subject: Re: FLASH: get property of button
From: Dickinson (Marcus)
Date: Mon, 27 Sep 1999 15:43:34 +0100

You need to put the button inside of a movie clip, then name the movie clip.

Hope this helps.
Marcus J. Dickinson
www.kimmuli.com
----- Original Message -----
From: Deanna Doelitzsch <deanna9999athotmail [dot] com>
To: <flasheratchinwag [dot] com>
Sent: September 27, 1999 10:22 AM
Subject: FLASH: get property of button


> How do you name an instance of a button? I'm trying to get the x and y
> position of a button to place a movie clip relative to it, but I can't
seem
> to be able to name the button instance. Is this possible? or am I going
> about this the wrong way?
>
> Thanks
> Deanna
>
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
>
> ------------------------------------------------------------------------
> To UNSUBSCRIBE send: unsubscribe flasher in the body of an
> email to list-manageratchinwag [dot] com. Problems to: helpatchinwag [dot] com
> N.B. Email address must be the same as the one you used to subscribe.
> For info on digest mode send: info flasher to list-manageratchinwag [dot] com
>
>


------------------------------------------------------------------------
To UNSUBSCRIBE send: unsubscribe flasher in the body of an
email to list-manageratchinwag [dot] com. Problems to: helpatchinwag [dot] com
N.B. Email address must be the same as the one you used to subscribe.
For info on digest mode send: info flasher to list-manageratchinwag [dot] com

Replies
  FLASH: get property of button, Deanna Doelitzsch

[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]