Re: FLASH: Tell Target help

[John Croteau]

Hi Billie,


> If I place a single button on the main timeline and give it the

> following action it works:

You can use this same action from anywhere in the movie.


> Begin Tell Target ("/movies")

> On (Release)

> Go to and Stop ("annotscene")

> End On

> End Tell Target


In general it is easier to use paths based from the root (they start

with /) since they work from anywhere in the movie. It is the same path

from the main timeline, from any movie clip on the main timeline or from

any movie clip inside of another movie clip. If you use a path that

starts from the root ' / ' there is no need to figure out the relative

path.

http://www.FlashBible.com/members/TellTarget/Paths.htm


-----------                               -----------------------

John Croteau

croteauerols [dot] com (mailto:croteauerols [dot] com)

-------------                             -------------------------

FlashTek  (Advanced Websites with Flash) http://www.FlashTek.com/

Flash Bible (Fast track to good Flash)  http://www.FlashBible.com/

Flash Central(The Universe Starts Here) http://www.FlashCentral.com/

The Flash Tech Resource (Tech Notes)   http://www.FlashCentral.com/tech/

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


------------------------------------------------------------------------

To UNSUBSCRIBE send: unsubscribe flasher in the body of an

email to

list-managershocker [dot] com

.  Problems to:

ownershocker [dot] com

N.B. Email address must be the same as the one you used to subscribe.

For info on digest mode send: info flasher to

list-managershocker [dot] com