Flasher Archive
[Previous] [Next] - [Index] [Thread Index] - [Previous in Thread] [Next in Thread]
Subject: | Re: FLASH: Adobe Dimensions export question... |
From: | John Foust |
Date: | Tue, 25 May 1999 19:36:42 +0100 |
At 08:41 PM 5/24/99 +0000, Nigel Randsley-Pena wrote:
>> When I export... to Flash format...does it perform a true
polygon-to-polygon > object-space clip?
>No it does not. Export from Adobe Dimensions is done in .ai format not
>swf format and no p2p object-space clipping occurs. What you get is a
>grouped object that can at times be quite complex. Basic shapes are ok
>but results of boolean operations are quite heavy. A good thing is that
>with a bit more work you can easily optimize after import into Flash
Are you saying that if I model a cube in Dimensions, then export
to AI, all six polygons are present in the drawing?
What about the pathological cases with concave or overlapping polygons,
like a bar through the center of a 'C' that's under the lower part but
above the upper part? Does Dimensions break apart any of the original
polygons so this AI drawing looks "right"?
- John
------------------------------------------------------------------------
To UNSUBSCRIBE send: unsubscribe flasher in the body of an
email to list-managershocker [dot] com. Problems to: ownershocker [dot] com
N.B. Email address must be the same as the one you used to subscribe.
For info on digest mode send: info flasher to list-managershocker [dot] com
Replies
Re: FLASH: Adobe Dimensions export quest, Nigel Randsley-Pena
Replies
FLASH: (Non-Flash) Design tips etc., Philip Likens
Re: FLASH: (Link Sucks)Flashers got a se, Philip Likens
Re: FLASH: (Link Sucks)Flashers got a se, Tyson H.
Re: FLASH: (Link Sucks)Flashers got a se, Philip Likens
Re: FLASH: (Link Sucks)Flashers got a se, Tyson H.
FLASH: Adobe Dimensions export question., John Foust
Re: FLASH: Adobe Dimensions export quest, Nigel Randsley-Pena
[Previous] [Next] - [Index] [Thread Index] - [Next in Thread] [Previous in Thread]